Nordost Odin 2 Bi-Wire Jumpers

Uncompromised Terminal Linkage for Reference Loudspeakers | Available at Trimira Audio

The Nordost Odin 2 Bi-Wire Jumpers are flagship speaker-terminal jumpers designed to replace conventional metal plates and basic wire links supplied with bi-wireable loudspeakers.

Using construction derived from the Odin 2 Speaker Cable, these jumpers combine Dual Mono-Filament technology, silver-plated solid-core OFC conductors, flat-ribbon geometry, mechanically controlled construction, and low-mass HOLO:PLUG® terminations.

They provide a premium connection between the high-frequency and low-frequency binding posts when a loudspeaker is driven from a single speaker-cable run.

At Trimira Audio, we recommend the Odin 2 Bi-Wire Jumpers for uncompromising loudspeaker systems where consistency with a flagship speaker-cable installation is important.

Key Features & Technological Innovations

Patented Dual Mono-Filament Construction

Each conductor is spiral-wrapped with two helical FEP strands before being enclosed in an extruded FEP outer jacket.

This creates a low-contact dielectric environment designed to minimize dielectric interaction and energy storage while supporting rapid signal propagation.

Silver-Plated Solid-Core OFC Conductors

The jumpers employ high-purity 99.999999% solid-core OFC copper with 85 µm pure silver plating.

The solid-core construction provides consistent conductor geometry without the strand interaction associated with conventional jumper wires.

Flat-Ribbon Extrusion Geometry

The jumper construction follows the parallel conductor architecture of the Odin 2 speaker cable, maintaining a consistent low-mass geometry between the loudspeaker's high- and low-frequency terminals.

Mechanically Tuned Length & Resonance Control

The jumpers are manufactured to a precise 7-inch (17.7 cm) length, with controlled construction designed to manage electrical and mechanical characteristics over the short terminal connection.

Custom Low-Mass HOLO:PLUG® Terminations

Odin 2 Bi-Wire Jumpers can be configured with proprietary HOLO:PLUG® speaker connectors:

• Spade-to-spade
• Banana-to-banana
• Spade-to-banana
• Banana-to-spade

This allows the termination to be matched to the loudspeaker's binding-post arrangement.

Technical Specifications

Why Use Odin 2 Bi-Wire Jumpers?

When a bi-wireable loudspeaker is operated with a single speaker-cable run, the jumper connection carries the signal between the amplifier cable's connection point and the loudspeaker's second crossover terminal.

Using a purpose-built jumper constructed from the same design philosophy as the main speaker cable provides a consistent solution rather than relying on generic stamped metal links or basic wire straps.

For systems already using Odin 2 Speaker Cable, Odin 2 Bi-Wire Jumpers provide a particularly cohesive terminal-link solution.

Consult with the Audio Specialists at Trimira Audio

The Nordost Odin 2 Bi-Wire Jumpers are intended for reference loudspeakers where the final connection between binding posts is treated as part of the overall speaker-cable system.

Trimira Audio can assist with:

• Spade versus banana selection
• Mixed termination configurations
• Binding-post compatibility
• Jumper orientation
• Single-wire versus bi-wire configuration
• Matching jumpers to Odin 2 or other Nordost speaker cables
• Reference-system auditions

For a flagship terminal connection, Odin 2 Bi-Wire Jumpers combine Dual Mono-Filament construction, silver-plated solid-core OFC, flat-ribbon geometry, mechanically controlled construction, and HOLO:PLUG® termination options.